E4BIKE Classic (DD hub motor + sine wave contr. kit) - 1000 W

* Max speed on a flat horizontal asphalt road, no wind, with a fully charged battery, 26" wheel, with a 175 cm / 80 kg pilot, not pedalling.

The kit contains:

• Direct drive hub motor spoked in high quality rim - front or rear;
• Hub motor sine wave controller with torque control and 26-60 V working voltage range (36V, 48V and 52V batteries are supported);
• Full twist throttle with battery indicator (only 48V supported) and on/off button;
• Shimano 6-speed freewheel (in case of a rear motor).

Hub motor specs (Classic - Torque version)

• Rated power - 1000 W, peak power 1.5 kW (stock Mark I controller) and up to 3 kW (optional Mark II controller);
• 0.35 mm lams;
• Stator base made of aluminum;
• 7Tx9 windings;
• Required dropout width is 135 mm for rear motor and 100 mm for a front;
• Axle size - 14 mm round, 10 mm flat,
• Weight - ~6.5 kg without rim, ~7.5 kg with rim;
• Disk brake mount;
• Motors are spoked in 24", 26" and 28" PowerCircle rims;
• 6th spare wire in the cable for easy thermal sensor installation (no sensor in stock).
• Labeled 250 W (for legal reasons)

Controller specifications

• Working voltage range: 26-60 V;
• Maximum battery current: 30A;
• Throttle controls current;
• Sine wave phase current;
• Brake handles connector;
• PAS connector;
• 3-pos power regulator switch connector for battery current limiting - 10/20/30 A, i.e. 500/1000/1500 W electric power with 48V battery.

This video shows the comparision between Classic and Classic-S motors with stock Mark I and optional Mark II controllers. Same road, same bike, same fully charged battery and same rider were used.